YamahaR125.COM
EAS27290
TROUBLESHOOTING
• Any of the following fail to light: turn signal lights, brake light or indicator lights.
• The horn fails to sound.
• The fuel gauge fails to operate.
• The speedometer fails to operate.
NOTE:
• Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
3. Left upper side cowling
4. Right side panel
5. Left lower side cowling
1. Check the fuses.
(Main, ignition, and signaling sys-
tem)
Refer to "CHECKING THE FUS-
ES" on page 8-63.
OK ↓
2. Check the battery.
Refer to "CHECKING AND
CHARGING THE BATTERY" on
page 8-64.
OK ↓
3. Check the main switch.
Refer to "CHECKING THE
SWITCHES" on page 8-59.
OK ↓
4. Check the entire signaling system
wiring.
Refer to "CIRCUIT DIAGRAM" on
page 8-19.
OK ↓
Check the condition of each of the sig-
naling system circuits. Refer to
"Checking the signaling system".
Checking the signaling system
The horn fails to sound.
1. Check the horn switch.
Refer to "CHECKING THE
SWITCHES" on page 8-59.
OK ↓
NG →
Replace the fuse(s).
NG →
• Refill battery fluid.
• Clean the battery terminals.
• Recharge or replace the battery.
NG →
Replace the main switch.
NG →
Properly connect or repair the signaling
system wiring.
NG →
The horn switch is faulty. Replace the left
handlebar switch.
8-21
SIGNALING SYSTEM
Need help?
Do you have a question about the YZF-R125 and is the answer not in the manual?
Questions and answers
Hello! I **** having 2 wires that does not connect with anything and can't connect ti each other. My motorcycle won't rev past 7000rpm so i thaught this might be the cause. Can you help me to figure out what can indo with those wires?
Check the leads, couplers, and connectors for stains, rust, or moisture. Disconnect the wires and inspect the terminals. If there is no continuity, clean the terminals. If moisture is present, dry them with an air blower. If rust or stains are found, connect and disconnect the wires several times to improve contact. Ensure all connections are secure and properly connected. If the issue persists, use a contact revitalizer.
This answer is automatically generated
Hi, dont know hov to Connect the small houe on the waterpump, is it the one that Connect to airbox??,
The small hose on the water pump of a Yamaha YZF-R125 is referred to as the water pump breather hose. The document does not provide specific instructions for connecting it. However, it is generally routed according to the cable routing diagram and should be securely attached to the designated fitting on the water pump, ensuring there are no kinks or obstructions.
This answer is automatically generated
Is the coolant reservoirhose conekted to the inlett on the right side on the waterpump?,