Replacing The Headlight Bulb - Yamaha YBR125 Custom Owner's Manual
Custom 2008
Hide thumbs
Also See for YBR125 Custom:
- Owner's manual (84 pages) ,
- Owner's manual (80 pages) ,
- Service manual (218 pages)
Table of Contents
Advertisement
CAUTION:
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "ON" and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
PERIODIC MAINTENANCE AND MINOR REPAIR
ECA10640
Replacing the headlight bulb
This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
1. Remove the headlight unit by re-
moving the screws.
1. Screw
2. Remove the headlight bulb socket
cover.
EAU43190
1. Headlight bulb socket cover
3. Remove the headlight bulb socket
1. Headlight bulb socket
4. Remove the defective bulb by
6-29
(together with the bulb) by turning
it counterclockwise.
1
pushing it in and turning it counter-
clockwise.
6
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the YBR125 Custom and is the answer not in the manual?
Questions and answers
I was riding my bike when it completely cut out. Now when I turn the ignition on I'm getting zero electrics. Checked wiring amd anybfises I can see and all seems fine
A Yamaha YBR125 Custom could have no electrical power after cutting out while riding due to a broken or disconnected wire in the wiring loom, particularly one going to the fuel pump. If the wire is damaged, the fuel pump may not receive power after the initial ECU priming, causing the engine to cut out and preventing restart. Another possible cause is a failure in the ignition circuit cut-off system, such as issues with the sidestand switch, clutch switch, or neutral switch, which can cut power if malfunctioning.
This answer is automatically generated