Replacing The Fuse - Yamaha YBR125 Custom Owner's Manual
Custom 2008
Hide thumbs
Also See for YBR125 Custom:
- Owner's manual (84 pages) ,
- Owner's manual (80 pages) ,
- Service manual (218 pages)
Table of Contents
Advertisement
PERIODIC MAINTENANCE AND MINOR REPAIR
CAUTION:
G
Always
keep
charged. Storing a discharged
battery can cause permanent
battery damage.
G
To charge a sealed-type (MF)
battery, a special (constant-volt-
age) battery charger is required.
Using a conventional battery
charger will damage the battery.
If you do not have access to a
sealed-type (MF) battery charg-
er, have a Yamaha dealer
charge your battery.
6
ECA10630
Replacing the fuse
The fuse is located behind panel A.
the
battery
(See page 6-6.)
To access the fuse, remove the starter
relay coupler.
1. Starter relay coupler
1. Fuse
2. Starter relay
EAU43211
The spare fuse is located on the rear of
the starter relay holder.
To access the spare fuse, remove the
starter relay (together with its holder) by
pulling it out, then turn the starter relay
over.
1
1. Starter relay
2. Starter relay holder
1
3. Spare fuse
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
2. Remove the blown fuse, and then
2
6-28
1
all electrical circuits.
install a new fuse of the specified
amperage.
Specified fuse:
15.0 A
2
3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the YBR125 Custom and is the answer not in the manual?
Questions and answers
I was riding my bike when it completely cut out. Now when I turn the ignition on I'm getting zero electrics. Checked wiring amd anybfises I can see and all seems fine
A Yamaha YBR125 Custom could have no electrical power after cutting out while riding due to a broken or disconnected wire in the wiring loom, particularly one going to the fuel pump. If the wire is damaged, the fuel pump may not receive power after the initial ECU priming, causing the engine to cut out and preventing restart. Another possible cause is a failure in the ignition circuit cut-off system, such as issues with the sidestand switch, clutch switch, or neutral switch, which can cut power if malfunctioning.
This answer is automatically generated