Maintenance; Resetting The Motor Thermostat - Shark NV22LWM Owner's Manual

Maintenance

Resetting the Motor Thermostat

Your Shark Upright Vacuum is
®
equipped with a protective Motor
Thermostat. If the motor should
overheat, the thermostat shuts off
the power.
To reset the Motor Thermostat:
Move the Power Button to the
"O – Off" position.
Unplug the vacuum.
Check for clogged hose or filter;
unclog hose and replace filter.
Refer to Checking for Blockages
on page 11.
12
TOLL FREE: 1-800-798-7398
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Turn the Power Switch to the
"I – On" position to start the
vacuum.
Note: if vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
A
1 C leaning the Pet Hair Power
Brush -
T urn the Turbo Brush over and
slide locking latch (A) forward.
G ently tilt brush housing upward
to open.
R emove debris from turbine
wheel and air passage.
T o reassemble, insert the tabs on
the front edge of the cover into
the matching holes in the top
half and tilt the cover back down
until it clicks into place.
Ordering Replacement Parts
To order additional parts and
accessories, go to
www.sharkclean.com
or call 1-800-798-7398.
PART
Super Stretch Hose
Dusting Brush &
Crevice Tool
Foam & Felt Filters
Turbo brush
Cleaning Wand
PART NO.
1114-FC
1115-FC
XF22
1144-FC
1116-FC