Checking For Blockages; Cleaning The Brushroll; Cord Maintenance - Shark Navigator LIFT-AWAY ADV LA360 Series Owner's Manual

MAINTENANCE
Self-Cleaning Brushroll
The self-cleaning brushroll actively removes hair wrap as you vacuum. If any hair is wrapped
around the brushroll, continue vacuuming. This will allow the self-cleaning brushroll to remove
the hair wrap and send it to the dust cup. If some hair wrap remains after continued use, remove
the cover from the bottom of the nozzle and carefully clean off the brushroll.

CLEANING THE BRUSHROLL

To access the nozzle hose, pinch the release touchpoints on the bottom of the nozzle, then lift
the cover and clear any blockages.
DEBRIS WRAPPED
AROUND BRUSHROLL
Clean off any debris on the bristles.

CORD MAINTENANCE

To minimize the risk of power cord damage,
DO NOT run the vacuum over the power
cord.If this occurs, immediately shut off
power to the vacuum and remove the cord
from the brushroll or nozzle.
s h a r kc l e a n . c o m
1. 1. DO NOT pull or carry vacuum cleaner
by the cord or use cord as a handle.
2. 2. DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3. 3. DO NOT close the door on the cord.
4. 4. DO NOT pull the cord around sharp
corners.
5. 5. DO NOT leave the cord near heated
surfaces.

CHECKING FOR BLOCKAGES

DUST CUP BLOCKAGES
Detach dust cup from vacuum pod.
Empty dust cup and remove debris from
lint screen in the top of the dust cup.
HOSE BLOCKAGES
Detach hose from handle by pressing
on the release button at the top
of the hose. Detach the hose from
the pod, and check openings
for blockages.
NOZZLE BLOCKAGES
Detach wand and pod from floor
nozzle, tilt nozzle neck back, and
check opening for blockages.
WAND BLOCKAGES
Detach wand from pod and handle,
and check both ends for blockages.
HANDLE BLOCKAGES
Detach handle from wand and hose to
check the openings on both ends.
s h a r kc l e a n . c o m