Throttle Cable - Husqvarna SG 13 B Operator's Manual

Checking Engine Oil Level
Make sure that the machine is parked on flat ground
with the engine stopped when checking the oil level.
1. Unscrew the dipstick and wipe it using paper towel
or a lint-free rag.
2. Replace the dipstick without screwing it in.
Remove and check the level on the dipstick.
3. Fill oil as necessary to the lip of the dipstick hole.
Oil type, see above.
4. Check that the rubber gasket is in position and
screw the dipstick back into place. DO NOT
tighten it askew or too hard or you may damage
the threads.
Right wheel
Lubricate using a grease gun until the grease
squeezes out one nipple.
Use good quality MP grease. Grease from well-known
brand names (petrochemical companies, etc.) usually
maintains a good quality.

Throttle cable

Peel back the rubber covers at both of the cable
mountings. Grease both ends of the throttle cable
and move the controls to end stop positions when
lubricating. Refit the rubber covers on the cable after
lubrication. Cables with sheaths will bind if they are
not lubricated regularly. Binding in a cable may cause
malfunction.
If the cable binds, remove the cable and hang it
vertically. Lubricate it with thin engine oil until the oil
begins to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that
it seals against the casing and allow the cable to hang
vertically from the bag overnight. If you do not succeed
in lubricating the cable, it must be replaced.
LUBRICATION
8011-020
8011-231
8011-234
-45
HUSQVARNA