Husqvarna SG 13 B Operator's Manual page 15

7. Set the brake rod assembly into the brake bracket.
The brake rod assembly needs to be adjusted
before connecting the yoke to the brake. Turning
the yoke clockwise shortens the rod, tightening
the grip on the brake disc by the brake pads.
Counterclockwise loosens the clamping force.
8. After adjustment, attach the yoke to the brake's
top mounting hole using the clevis pin and cotter
pin.
9. Turn the adjustment nut against the spring and
washer until the spring set snugly against the
brake bracket and has a small amount of tension.
With proper brake adjustment, the wheel will slide,
but not turn, when the handle is over center.
To engage brake, pull back on the handle until
brake rod assembly goes "over center" and locks
the brake ON. Test for proper tension and grip.
10. Remove air cleaner and double wire clamp from
engine.
11. Route the wire harness from engine and the throttle
cable through guide and handle crossmember.
12. Connect upper and lower wire harness together,
yellow to yellow—black to black.
16 -
HUSQVARNA
SET-UP
ADJUSTMENT NUT
CLEVIS PIN
CLAMP
THREAD WIRE HARNESS
AND THROTTLE CABLE
BRAKE BRACKET
HAIR PIN
GUIDE