EC190/200 intro 5-12-2001 13:43 Pagina 2 ELECTRICAL CONNECTION (UK ONLY) If your appliance comes fitted with a plug, it will incorporate a 13 If the plug is a moulded-on type, the fuse cover must be re-fitted when Amp fuse. If it does not fit your socket, the plug should be cut off changing the fuse using a 13 Amp Asta approved fuse to BS 1362.
Page 3
EC190/200 intro 5-12-2001 13:43 Pagina 3...
Page 4
EC190/200 intro 5-12-2001 13:43 Pagina 4...
Page 5
EC190/200 intro 5-12-2001 13:43 Pagina 5...
EC190/200 GB 5-12-2001 13:44 Pagina 6 Thank you for choosing this coffee machine. To get • Never touch the appliance with wet or damp hands • The appliance is not intended for use by young the very best out of your new coffee machine it is advisable to read these instructions before using the children or infirm persons without supervision.
EC190/200 GB 5-12-2001 13:44 Pagina 7 USING YOUR MACHINE FOR THE FIRST 4.Empty the cup, wait until the “OK” pilot light comes on again and repeat the whole operation one more TIME time. When you are using the machine for the first time, you 5.For optimum preheating, the selector knob can be left should wash all the accessories i.e.
EC190/200 GB 5-12-2001 13:44 Pagina 8 6.To detach the filter holder, turn the handle from right to left. ATTENTION: to avoid spraying, never detach the filter holder while the machine is brewing coffee. 7.To remove the used coffee, hold the filter locked with the special lever that is built into the handle and let the coffee fall out by knocking the overturned filter holder (Fig.
EC190/200 GB 5-12-2001 13:44 Pagina 9 IMPORTANT: always clean the milk frother and steam • press the filter holder button and remove the filter, as indicated in fig. 22 nozzle immediately after use. Proceed as follows: • check that the pinholes of the filter are not blocked. If 1 By turning the steam knob (fig.
Page 10
EC190/200 GB 5-12-2001 13:44 Pagina 10 8.Turn the selector knob to the position and allow all of the remaining solution in the tank to flow out (fig. 8). 9.Turn the selector knob to the position (fig.5) and repeat operations 7 and 8 one more time. Repairs for malfunctioning caused by problems of calcium build-up are not covered by the guarantee if the descaling process described above is not carried...
Page 11
EC190/200 GB 5-12-2001 13:44 Pagina 11 PROBLEM POSSIBLE CAUSES SOLUTION Espresso coffee no longer •The coffee is damp and/or • Prepare the coffee again, pressing it more comes out. excessively pressed lightly and/or changing the powder • The holes in the filter holder spouts •...
Need help?
Do you have a question about the EC200 and is the answer not in the manual?
Questions and answers