Related Manuals for Shoprider STREAMER Sport 888WA
Summary of Contents for Shoprider STREAMER Sport 888WA
- Page 1 ISO9001 ISO14001 ISO13485 CERTIFIED MEDICAL POWER WHEELCHAIR Owner’s Manual ATTENTION Please read your owner’s manual before driving your power wheelchair. STREAMER Sport 888WA...
-
Page 2: Table Of Contents
ISO9001 ISO14001 ISO13485 CERTIFIED CONTENTS INTRODUCTION page 3 FEATURE GUIDE page 3 OPTIONAL ACCESSORY page 4 EMI WARNING page 5 – 6 SAFETY INSTRUCTIONS page 7 – 8 INDICATION LABEL LOCATION page 9 PREPARATION FOR USE page 10 PROGRAMMABLE CONTROLLER page 10 ADJUSTMENT PROCEDURES page 11 –... -
Page 3: Introduction
Powerchair. Please read it carefully before using the Powerchair and make sure you understand all the instructions. Warning! Please make sure that you are physically fit to operate this unit. Consult your dealer/doctor for advice. FEATURE GUIDE STREAMER SPORT (888WA) Headrest (adjustable with selected height) Backrest... -
Page 4: Optional Accessory
ISO9001 ISO14001 ISO13485 CERTIFIED OPTIONAL ACCESSORY Item Accessory Part Example Adjustable Height Footrest Adaptor Elevating Leg Rest (6-hole adjustable as standard. 10- hole adjustable with 60mm extension is optional.) Swing-Away Joystick Mount Bracket Remark: For other available accessories if required, please consult your authorized provider. -
Page 5: Emi Warning
ISO9001 ISO14001 ISO13485 CERTIFIED EMI WARNING ELECTROMAGNETIC INTERFERENCE (EMI) FROM RADIO WAVE SOURCES Medical Power Wheelchairs (Hereinafter referred to as “Powerchair”) may be susceptible to electromagnetic interference (EMI), which is a kind of interfering electromagnetic energy (EM) emitted from sources such as radio stations, TV stations, amateur radio (HAM) transmitters, two-way radio, and cellular phones. - Page 6 ISO9001 ISO14001 ISO13485 CERTIFIED EMI WARNING POWERCHAIR ELECTROMAGNETIC INTERFERENCE (EMI) Because EM energy rapidly becomes more intense as one moves closer to the transmitting antenna (source), the EM fields from hand-held radio sources (transceivers) are of special concern. It is possible to unintentionally bring high levels of EM energy very close to the Powerchair’s control system while using these devices.
-
Page 7: Safety Instructions
ISO9001 ISO14001 ISO13485 CERTIFIED SAFETY INSTRUCTIONS Please use your Powerchair often and let it expand your horizons. The more mobility your Powerchair brings, the happier you will be! But, with all things, observing a few rules will ensure safe maneuvering. So please… (1) Do not drive the Powerchair without reading this instruction manual. - Page 8 ISO9001 ISO14001 ISO13485 CERTIFIED SAFETY INSTRUCTIONS (19) Whenever a center bolt of the wheel assembly has been loosened, please replace with a specified new bolt from authorized providers and secure with a torque of 240 5 kg-cm together with Loc-tite 271 adhesive (or equivalent). (20) When proceeding up any incline, please move the seat to the most forward position or if you have the deluxe seat, make sure that it is in the 90 degree (upright) position.
-
Page 9: Indication Label Location
INDICATION LABEL LOCATION To ensure your safety and protect the Powerchair from damage, please read the safety instructions in this manual and familiarize yourself with the labels listed below. Labels on Chassis Shroud of STREAMER SPORT (888WA) Battery Wiring Diagram Drive Drive... -
Page 10: Preparation For Use
Charge the Powerchair for at least 6-8 hours prior to first time use. PROGRAMMABLE CONTROLLER STREAMER SPORT (888WA) Powerchair has a programmable controller. For more information regarding the programming parameters for the programmable Powerchair controller please contact your provider. -
Page 11: Adjustment Procedures
ISO9001 ISO14001 ISO13485 CERTIFIED ADJUSTMENT PROCEDURES ARM ADJUSTMENTS (Fig.3) ANGLE Pull up on the end of the armrests and they will flip back up allowing easy transfer in and out of the seat. Under the armrest, there is a bolt and lock nut (1) that can be adjusted up or down to change the angle of the armrest. - Page 12 ISO9001 ISO14001 ISO13485 CERTIFIED ADJUSTMENT PROCEDURES JOYSTICK CONVERSION (right to left or left to right) Loosen the hand knob [Fig.3 (3)] and remove the entire armrest assembly with the joystick attached. Place the armrest assembly on the desired side. Reset in position by re-tightening the hand knobs to complete joystick conversion.
-
Page 13: Operation Instructions
ISO9001 ISO14001 ISO13485 CERTIFIED OPERATION INSTRUCTIONS JOYSTICK CONTROLLER (SHARK 40) OVERVIEW On / Off Button (1) This button turns the joystick controller (hereinafter referred to as SHARK 40 joystick) on and off. Do not use this button to stop the Powerchair, except in an emergency. Speed Decrease Button (2) This button decreases the maximum speed. - Page 14 OPERATION INSTRUCTIONS Charging Port (10) for Off-Board Charger Only plug a Shoprider certified charger into this port. This port should not be used as a power supply for any other electrical devices. Disregarding this will void the warranty of the Powerchair.
-
Page 15: Disassembly & Assembly Instructions
ISO9001 ISO14001 ISO13485 CERTIFIED DISASSEMBLY & ASSEMBLY INSTRUCTIONS Fig. 6 COMPONENTS FOR STREAMER SPORT (888WA) (1) Captain seat assembly with arm assembly. (2) Chassis shroud. (3) Chassis assembly. (4) Batteries. (5) Charger (Off-Board) ~15~... - Page 16 ISO9001 ISO14001 ISO13485 CERTIFIED DISASSEMBLY & ASSEMBLY INSTRUCTIONS DISASSEMBLY PROCEDURES WARNING! We advise caution when disassembling and lifting items. You must ensure that the person undertaking these actions is able to handle the weight. STEP 1 Ensure the area where the Powerchair is to be dismantled is spacious. STEP 2 Disconnect the plug of the SHARK 40 joystick cable.
-
Page 17: Batteries & Battery Charging
ISO9001 ISO14001 ISO13485 CERTIFIED BATTERIES & BATTERY CHARGING BATTERIES The Powerchair is supplied with 2 x 26 Ah sealed lead acid, maintenance free batteries. These are located under the seat in the center of the Powerchair. For easy handling, Velcro or plastic carrying straps may be provided to assist in installation or removal of the batteries. - Page 18 ISO9001 ISO14001 ISO13485 CERTIFIED BATTERIES & BATTERY CHARGING The following table indicates what the gauge will display for any given state. Display Description This means Notes All LEDs OFF Power is OFF All LEDs ON Power is ON Less LEDs imply a steady reduced battery charge.
- Page 19 ISO9001 ISO14001 ISO13485 CERTIFIED BATTERIES & BATTERY CHARGING BATTERY CHARGING (UNITS EQUIPPED WITH OFF-BOARD CHARGER) Familiarize yourself with the safety information below prior to using the battery charger. SAFETY INFORMATION 1. Read the battery charger instructions in this manual and in the manual supplied with the charger prior to charging the batteries.
- Page 20 ISO9001 ISO14001 ISO13485 CERTIFIED BATTERIES & BATTERY CHARGING CHARGING INSTRUCTIONS 1. Connect the charger to the charging port at the front of the SHARK 40 joystick (item 8 in Fig.5) 2. Plug the charger into the wall outlet. 3. The charging process will start automatically. CHARGER INDICATION LIGHTS Blinking Green –...
-
Page 21: Trouble Shooting
ISO9001 ISO14001 ISO13485 CERTIFIED TROUBLE SHOOTING The Self-Help Guide (Table 1) is intended to assist in the location of a fault that may occur in a certain part of the Powerchair. Flash codes indicate the nature of an abnormal condition directly from the SHARK joystick Information Gauge. - Page 22 ISO9001 ISO14001 ISO13485 CERTIFIED TROUBLE SHOOTING LOCK MODE: The SHARK 40 joystick can be locked to prevent unauthorized use. The locking method is achieved through a sequence of key presses and joystick movements, as detailed below. To lock Powerchair controller: ...
-
Page 23: Specification
Charger Type On / Off Board Off Board 24V, 5A ® ® All specifications are subject to change without prior notice. SHOPRIDER / PIHSIANG reserves rights of any changes on the unit. 1. Includes the anti-tip wheel. 2. The actual driving range varies with the factors shown below. -
Page 24: Disclaimer
SHOPRIDER MOBILITY PRODUCTS, INC 21184 S. FIGUEROA ST CARSON, CA 90745 800-743-0772 P/N: 300904-57-A6C ® ® © Copyright PIHSIANG MACHINERY MFG. CO., LTD. 2003. All rights Reserved. SHOPRIDER / PIHSIANG are registered trademarks of PIHSIANG MACHINERY MFG. CO., LTD. ~24~...
Need help?
Do you have a question about the STREAMER Sport 888WA and is the answer not in the manual?
Questions and answers
how do i get the seat off to change the battery?
To remove the seat on a Shoprider STREAMER Sport 888WA to change the battery, follow these steps:
1. Ensure Safety: Make sure the area is spacious and safe for disassembly.
2. Disconnect VSI Cable: Remove the plug at the end of the VSI cable by pulling on the pull ring. Lay it down carefully to avoid damage.
3. Remove Arm Assembly (Optional): To make lifting easier, detach the arm assembly if needed.
4. Loosen Seat Knobs: Under the rear of the seat assembly, locate and release the two hand knobs.
5. Lift the Seat: Carefully lift the seat off the powerchair to access the batteries.
Once the seat is removed, you can proceed with the battery replacement.
This answer is automatically generated
What causes reset button to not work