Yamaha CL5 Supplementary Manual page 13

Messages
Error, warning, and information messages are displayed. Messages are also displayed in the Dante
Controller Error Status field.
Each indicator lights or flashes as described below:
No call-out The indicator is off.
Light The indicator remains lit steadily.
Flash The indicator continues to flash.
Flash x2 The indicator flashes twice cyclically.
Flash x3 The indicator flashes three times cyclically.
■ Error Messages
The SYSTEM indicators will remain lit/blinking as follows until the problem has been resolved.
If service is necessary, please contact the Yamaha service center listed in the CL5/CL3/CL1 owner's
manual.
SYSTEM Indicators Description
An internal error has occurred.
Flash x2
The MAC address setting has
been corrupted and no
communication can occur via
Dante.
Flash x3
The internal memory has
been corrupted.
Light Flash x3
UNIT ID is not unique.
Light
Possible Solution
The device has failed. Contact your
Yamaha dealer for repair.
Use the front-panel DIP switches to
set START UP MODE to REFRESH,
then restart the unit. If the problem
persists after setting START UP
MODE back to RESUME, consult your
Yamaha dealer.
Set a unique UNIT ID number for the
Dante network.
13
SYSTEM Indicators Description
The DIP switches are not set
correctly.
Flash
Dante flow number limit was
exceeded.
Light Flash
■ Warning Messages
The indicators will light and/or flash as shown until the cause is resolved.
If the green [SYNC] indicator is unlit, the unit's clock is unconfirmed.
SYNC Indicators Description
The word clock is not set
correctly.
Flash
Dante Network circuit is
broken.
Flash x2
Other Dante-compatible
devices cannot be found due
to an incorrectly-wired Dante
Network.
Flash x3
I/O device and external head amp
Possible Solution
Check the DIP switch settings, and set
them correctly.
Examine the Dante network routing.
Possible Solution
Set the clock master and sampling
frequency correctly on the CL5/CL3/
CL1-native device or in Dante
Controller.
Make sure that the Ethernet cables
are not removed or short-circuited.
Make sure that the Ethernet cables
are connected correctly.
V1.7 Supplementary Manual