Scanner Connection; Calibrating The Scanner - Plustek OpticSlim 2600 User Manual

Scanner Connection

The first step to take when troubleshooting connection problems with your scanner
is to check all physical connections. The icon
tray, indicates if the scanner software is properly launched and the scanner and
computer are communicating with each other.
Appearance
No Display

Calibrating the Scanner

Calibrate the scanner if colors appear in areas that should be white, or colors of the
scanned image and the original vary a lot. This allows you to adjust and compensate
for variations that can occur in the optical component over time by its nature.
The following describes how to calibrate the scanner:
1. Click Start > All Programs > Your scanner model name > Calibration
Wizard. (For Windows 8 users: Point your mouse cursor to the upper or lower
right corner of your screen to open the Charm bar. Click on the Search charm.
The Apps screen will be shown. Click on an empty space in the Apps screen,
move your cursor to the right edge of the screen to scroll right until you find
Your scanner model name, and then click on Calibration Wizard.)
2. Click Next from the Calibration Wizard that pops up.
3. Click Calibrate Now....
4. After the calibration is complete, click OK and then click Finish.
The program has been successfully launched and the
scanner is connected with the computer, ready to scan
images.
The scanner is not connected with the computer.
You have chosen to terminate the program, no matter the
scanner is connected or disconnected with the computer.
15
, located on the Windows system
Status