Final Transmission Oil - Yamaha VINO 125 Owner's Manual

Final transmission oil<IXE>
Tightening torque:
Engine oil drain bolt A:
23 Nm (2.3 m•kgf, 16.6 ft•lbf)
Engine oil drain bolt B:
32 Nm (3.2 m•kgf, 23.1 ft•lbf)
NOTE:
Make sure that the O-ring is properly
seated.
8. Add the specified amount of the
recommended engine oil, and then
install and tighten the engine oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil change quantity:
1.00 L (1.06 US qt) (0.88 Imp.qt)
cC
8 8 8 8 8 Do not use oils with a diesel
specification of "CD" or oils of a
higher quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
PERIODIC MAINTENANCE AND MINOR REPAIR
8 8 8 8 8 Be sure no foreign material en-
ters the crankcase.
9. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off and
check for the cause.
10. Turn the engine off, and then check
the oil level and correct it if neces-
sary.
11. Install the panel.
ECA11670

Final transmission oil

The final transmission case must be
checked for oil leakage before each ride.
If any leakage is found, have a Yamaha
dealer check and repair the scooter. In
addition, the final transmission oil must
be changed as follows at the intervals
specified in the periodic maintenance
and lubrication chart.
1. Start the engine, warm up the final
2. Place the scooter on the
3. Place an oil pan under the final
4. Remove the oil filler cap and drain
6-11
transmission oil by riding the
scooter for several minutes, and
then stop the engine.
centerstand.
transmission case to collect the
used oil.
bolt to drain the oil from the final
transmission case.
EAU20061
1
2
3
4
5
6
7
8
9