Advertisement
TRANSCRIPTION
1. Press the POWER button (button DOWN).
2. Load the microcassette to be played
3. Press the RESET button to set the counter to "000".
- The tape counter helps you to quickly locate recorded selections for
playback.
- The tape counter will be set to "000" when the tape is ejected.
4. Set the SPEED button to 2.4 or 1.2 to correspond with the recorded tape
speed.
5. Press the PLAY switch on the foot control to begin transcribing. Play-
back will continue while the switch is being pressed.
- Playback can also be started by pressing the PLAY button on the unit.
In this case, the STOP button can be pressed to stop playback.
6. Adjust the VOLUME and TONE controls as desired.
7. Use the SPEED control to adjust the playback speed to your liking.
- The "0" position on the scale is for normal tape speed.
8. lf you wish to review your dictation, release the PLAY switch. The tape
automatically
backspaces according to the BACKSPACE control setting.
- Use the BACKSPACE controlto adjust the automatic backspace feature
for your convenience.
- For a longer review, press and hold the BACK switch and the tape
backspaces continuously until you release the BACK switch.
To pause, release the PLAY switch
Continue with this start-stop method until the transcription is completed.
To turn the unit off, press the POWER button (button UP).
9 .
1 0 .
-E5-
.J",
-E6-
I
lndex search
1. Press the SEARCH button (button DOWN).
2. Press the REW or FFWD button on the unit.
The tape stops briefly and a beep tone sounds when the tape reaches the
index mark you have recorded.
- When using the foot control, press the BACK switch.
NOTE:
The index marks are made on the SANYO TRC-6300 Memo-scriber.
Erasing
After transcription
is completed, you can erase the microcassette'
1. While holding down the ERASE button, press the REW button
The ERASE and REW indicators will light.
2. When the tape reaches the end, a beep tone sounds. Press the STOP button
to stop erasing.
- You can also perform "foruard erasing" by pressing both the ERASE and
FFWD buttons.
Use as a tape player
You can also play a pre-recorded microcassette on the unit. Load a microcassette
and press the PLAY button. Use the FFWD or REW button to advance or rewind
the tape rapidly.
Safeguards against accidental erasure
To protect side A, break out tab (1). To protect side B, break out tab (2).
- To record or erase a protected cassette, cover the erase guard tab openings
with adhesive tape (3).
.. a
q
3
Advertisement
