Table of Contents
Advertisement
TROUBLESHOOTING
Most treadmill problems can be solved by following
the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see
page 18). Use only a surge suppressor that meets
all of the speci cations described on page 18.
IMPORTANT: The treadmill is not compatible
with GFCI-equipped outlets and may not be
compatible with AFCI-equipped outlets.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for ve minutes and then press
the switch back in.
c
Tripped
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for ve minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for ve
minutes, and then plug it back in.
Reset
33
c. Remove the key from the console, and then
reinsert it.
d. If the treadmill still will not run, please see the front
cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a. The console features a display demo mode,
designed to be used if the treadmill is displayed in
a store. If the displays remain lit when you remove
the key, the demo mode is turned on. To turn off the
demo mode, hold down the Stop button for a few
seconds. If the displays are still lit, see step 7 on
page 28 to turn off the demo mode.
SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Remove the ve #8 x 3/4"
Screws (5). Carefully pivot the Motor Hood (62) off.
a
62
5
5
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Elite 5700 Treadmill and is the answer not in the manual?
Questions and answers
The treadmill will not come on, we have tried resetting and checked the power surge bar and it is fine
The NordicTrack Elite 5700 Treadmill may not turn on after resetting and checking the power surge bar due to the following reasons:
1. Tripped Power Switch: The power switch may have tripped. Wait five minutes and press the switch back in.
2. Unplugged Power Cord: Ensure the power cord is properly plugged in. If already plugged in, unplug it, wait five minutes, and plug it back in.
3. Reed Switch Misalignment: The Reed Switch and Magnet on the left side of the Pulley may be misaligned. Align the Magnet with the Reed Switch.
4. Overtightened Walking Belt: If the walking belt is too tight, treadmill performance may decrease, preventing it from turning on.
Check these potential issues to troubleshoot the problem.
This answer is automatically generated