GE 164D2966P087 Use And Care Manual page 25

The display will flash "PROBE" and the oven
control will signal if the probe is inserted into
the outlet, but the oven is not programmed for
the probe.
Your double oven has controls for the upper oven
and the lower oven. Be sure to set the correct
control. Pads on the left side of the panel are for
the upper oven. Pads on the right side of the panel
are for the lower oven. The TIMER ON/OFF,
COOK TIME, STOP TIME, INCREASE and
DECREASE pads can be used for either oven.
1. the
Insert probe
into
2. Plug [he probe
into the outlet
in the oven.
pushed all the
the oven door.
PROBE
4. the INCREASE or DECREASE
pad until the desired internal probe
temperature is displayed.
5. Press the BAKE pad.
BAKE
6. Press the INCREASE or DECREASE pad. The
last oven set temperature appears in the display.
Continue pressing until the desired oven
temperature is displayed.
The oven will start automatically. The words
"BAKE ON" and the roasting temperature yOLI set
After a few seconds, the words "LO PROBE" will
replace the roasting temperature in the display.
After the internal temperature of the meat reaches
o shown in the display.
7. When the internal temperature of the
meat reaches the number you have
CLEAR
set, the probe and the oven turn off
OFF
and the oven control signals. To slop
the signal, press the CLEAWOFF
pad. Use hot pads to remove the probe
from the food. Do not use tongs to
pull on it–they might damage it.
CAUTION: To prevent possible burns, do not
cooled. Do not store the probe in the oven.
NOTE:
final temperature is reached, a tone will sound and
the display will flash until the probe is removed
from the oven.
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
You can use the timer even though you cannot use
timed oven operations.
change temperature during
To the oven
Roast cycle, press the BAKE pad and then
the INCREASE or DECREASE pad to get the
the
25