Setting The Rinse Aid Dosage - Miele Classic G 4225 SC Operating Instructions Manual

Setting the rinse aid dosage

You can adjust the rinse aid dosage to
optimize the results.
The rinse aid dosage can be set at
levels between 0 and 6 ml. The factory
setting is 3 ml of rinse aid. This is just a
recommendation.
If the dishes are spotty:
^ Use a higher rinse aid setting.
If the dishes are cloudy or streaky:
^ Use a lower rinse aid setting.
Before using for the first time
^ Press the K button to turn the
dishwasher off.
^ Press and hold the Start/Stop button
and simultaneously turn the
dishwasher on using the K button.
Keep the Start/Stop button pressed
for at least four seconds until the
"Start/Stop" indicator light comes on.
If it does not come on, start over.
^ Press the Delay start button three
times.
The Delay start indicator light flashes 3
times at short intervals.
The time display shows the flashing
sequence p 3.
The set value is shown in the time
display after the P.
^ Select the desired dosage with the
Start/Stop button.
Every touch of the button increases
the level.
The setting is saved immediately.
^ Press the K button to turn the
dishwasher off.
13