Table of Contents
Advertisement
Before using for the first time
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
If the "Adjust Automatic" programme
function (depending on model) has
been activated, the amount of rinse aid
dispensed in the Automatic programme
can be higher than that set.
If spots appear on crockery and glass-
ware:
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
Decrease the rinse aid dosage.
28
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but-
ton.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Press the button 3 times.
The indicator will flash rapidly 3
times at intervals.
The dosage set will show in the display
after the symbol.
The flashing sequence will appear in
the display.
This indicates the factory default setting
3.
Use the programme selector button
to select the setting required.
Each press of the button moves you
up a level.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Advertisement
Table of Contents
