Yamaha WR250X Owner's Manual page 54

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
2
3
1. Oil filter element cover
2. Oil filter element cover bolt
4
6. Remove and replace the oil filter
element and O-rings.
5
TIP
Make sure that the O-rings are properly
6
seated.
7
8
9
1
1
1. O-ring
2. Oil filter element
7. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
8. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
9. Refill with the specified amount of
the recommended engine oil, and
2
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
6-12
then install and tighten the oil filler
cap.
Recommended oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
1.30 L (1.37 US qt, 1.14 Imp.qt)
With oil filter element replacement:
1.40 L (1.48 US qt, 1.23 Imp.qt)
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G Make sure that no foreign mate-
ECA11620