Bios Setup Utility; Getting Help - Lenovo IdeaPad Y410p User Manual
Hide thumbs
Also See for IdeaPad Y410p:
- Hardware maintenance manual (113 pages) ,
- User manual (90 pages) ,
- User manual (78 pages)
Table of Contents
Advertisement
Chapter 4. Troubleshooting
When do I need to restore the system to its factory status?
Use this feature when the operating system fails to start up. If there is critical data on the
system partition, back it up before starting recovery.
BIOS setup utility
What is the BIOS setup utility?
The BIOS setup utility is ROM-based software. It displays basic computer information and
provides options for setting boot devices, security, hardware mode, and other preferences.
How can I start the BIOS setup utility?
To start the BIOS setup utility:
1
Shut down the computer.
2
Press the Novo button and then select BIOS Setup.
How can I change the boot mode?
There are two boot modes: UEFI and Legacy. To change the boot mode, start the BIOS setup
utility and set boot mode to UEFI or Legacy support on the boot menu.
When do I need to change the boot mode?
The default boot mode for your computer is UEFI mode. If you need to install a legacy
Windows operating system (that is, any operating system before Windows 8) on your
computer, you must change the boot mode to Legacy support. The legacy Windows operating
system cannot be installed if you don't change the boot mode.
Getting help
How can I contact the customer support center?
See "Chapter 3. Getting help and service" in the Lenovo Safety and General Information Guide.
26
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the IdeaPad Y410p and is the answer not in the manual?
Questions and answers
how to add internet on the lenovo 410p
To connect the Lenovo IdeaPad Y410p to the internet, use one of the following methods:
1. Wireless LAN (Wi-Fi):
- Ensure the wireless LAN card is properly installed.
- If the card has two antenna connectors, connect the black cable (MAIN) to jack 1 and the white cable (AUX) to jack 2.
- If the card has three antenna connectors, connect the black cable to jack 1, the white cable to jack 2, and the grey cable to jack 3.
- Turn on Wi-Fi and connect to a wireless network using the system settings.
2. Wired LAN (Ethernet):
- Plug an Ethernet cable into the Ethernet port on the laptop.
- Connect the other end to a router or modem.
These methods allow the laptop to access the internet based on available hardware and network setup.
This answer is automatically generated