GE IM4A Owner's Manual And Installation Instructions page 28

WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS Q
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator ---
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4" and 5/16" Nutdrivers
CUT PLASTIC WATER TUBING
1
Measure 65" (165 cm) of water tubing starting
•
from where it is secured to the water valve. Cut
off excess tubing with a sharp knife or single-
edge razor blade.
Installation Instructions
L
Unplug the
Sharp knife
Pliers
Tape measure
65"
(165 cm)
or S
M N P Q R
ATTACH THE WATER VALVE
2
• Locate the female connector plug (C). Plug the
female connector (C) onto the male terminals on
the water valve (3). Either wire can go on either
terminal.
• Fasten the water valve to the cabinet edge hole
with the hex-head screw (10) from the kit.
DO NOT DRILL ANY ADDITIONAL HOLES.
28
C
3
10