Installation Instructions; Attaching The Cables And Power Cord To The Scanner - Hitachi SCI Getting Started Manual

Installation Instructions

Perform the following steps to install the scanner:
1. Place the scanner on top of the printer (or other designated location
near the printer).

Attaching the Cables and Power Cord to the Scanner

Attach the cables to the scanner as follows:
1. Locate the Operator Control Panel (OCP) cable that is taped to the
side of the scanner and plug it into the OCP connector as shown
below.
2. Plug the printer cable into the printer cable connector as shown
below.
3. Plug in the power cord as shown below.
Power Cord
Printer Cable
Printer Cable Connector
OCP Cable
OCP Connector
Unpacking and Setup 1-5