Connecting Wires To Terminals - Kenwood DDX6033BT Instruction Manual

Connecting Wires to Terminals

Bluetooth Microphone
(Accessory 6) DDX6033BT/
DDX6033BTM/DDX4033BT/
DDX4033BTM only
Antenna Cord
FM/AM antenna input
Accessory 1
Blue
(Antenna control wire)
Blue/White
(Power control wire)
Brown
(Mute control wire)
Orange/White
(Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire) · (To car chassis)
Extension cable (Accessory 7)
Purple/White
(Reverse sensor wire)
Light Green
FUSE ( 10A )
White ª / White/black · : To front speaker (left)
Gray ª / Gray/black · : To front speaker (right)
Green ª / Green/black · : To rear speaker (left)
Purple ª / Purple/black · : To rear speaker (right)
If no connections are made, do not let the cable come out from the tab.
Subwoofer Preout (monaural)
Connect to vehicle's reverse lamp
harness when using the optional rear
view camera.
(Parking sensor wire)
For best safety, be sure to
connect the parking sensor.
⁄
Connect to the vehicle's parking
brake detection switch harness.
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier or optional
smartphone adapter (KCA-ML100), connect to its power
☞
control terminal. ( page 81)
To the terminal that is grounded when either the telephone
rings or during conversation. (To connect the Kenwood
navigation system, consult your navigation manual.)
Not used
To car light control switch
ACC
Connect to vehicle's
steering remote harness.
Contact your Kenwood
dealer for details.
Extension cable (Accessory 2)
Ignition key switch
Car fuse box
(Main fuse)
Battery
English
79