Switching On And Off - Miele KF 9757 iD-3 Operating And Installation Manual

Switching on and off

Before using for the first time
Protective foil
The stainless steel trim to the interior
shelves and the door shelves has a
layer of protective foil to prevent
scratching during transportation.
^ Carefully remove the protective foil
from the stainless steel trim.
Cleaning and care
^ After removing the protective foil,
treat stainless steel surfaces with the
Miele stainless steel conditioning
agent supplied with the appliance
(available to re-order from
www.miele-shop.com).
Important. Each time it is used, the
Miele stainless steel conditioning
agent forms a water and dirt repellent
protective coating.
^ Clean the inside of the appliance and
the accessories with lukewarm water
and a little washing-up liquid, and
then dry with a soft cloth.
14
Switching on
The refrigerator and freezer sections are
switched on together by pressing the
master switch on the right hand side of
the control panel.
^ Press the master switch on the right
hand side of the control panel.
The temperature display for the
refrigerator section lights up, and the
interior lighting comes on when the door
is opened.
Bars light up in the temperature display
for the freezer section until the set
temperature is reached.
The appliance starts cooling.
To enable the temperature to get
sufficiently cold inside the appliance,
allow the appliance to run for a few
hours before placing food in it.
Cool pack
Insert the cool pack into the slots in the
roof of the freezer cabinet. To do this:
^ Remove the top freezer drawer.
^ Push the cool pack in at the back
and then press it upwards at the front
until it clicks into position.
The cool pack will be at its most
effective after it has been in the freezer
for approx. 24 hours.