Turn Area On/Off; Turn All Areas On; Turn All Areas Off; Move To Area - Bosch Solution 64 User Manual

Solution 64 User Guide
Main Office A001
Disarmed
Press OK or MENU
If the area is turned All On, the keypad will display:
Main Office A001
Armed All On
If the area is turned Part On, the keypad will display:
Main Office A001
Armed Part On
3. To exit, press [OK].
Areas > Commands >
Turn Area On/Off
This menu allows you to turn an area All On or off.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [1].
A list of different areas will display on the keypad.
A001 Reception Area
A002 Sales Dept 
A003 Administration Dept
Press , OK or MENU

If an area has already been turned All On or Part On, a
'tick' () will be displayed on the right side of the name
description (see A002 Sales Dept above).
2. Use the [↑] and [↓] keys to select the area that you want
to turn on or off, then press [OK] to select. Alternatively,
you can enter the area number you want to turn on or off,
then press [OK].
Areas > Commands >

Turn All Areas On

This menu allows you to turn on all areas that your PIN has been
assigned to at the same time All On. The keypad display below
shows the area icons 1 through to 8.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [2].
The keypad will display the exit time bar to prompt you
to exit all areas. You should leave all areas now.
14
When exit time has expired, the keypad will display that
all areas are turned All On (Armed).
i
Note
Areas > Commands >
Turn All Areas Off
MENU 2-0-1
This menu allows you to turn off all areas that your PIN has been
assigned to at the same time. However, this menu requires at
least one area that has a keypad assigned to it to be disarmed
before you can access this command.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [3].
Areas > Commands >

Move To Area

This menu allows you to operate multiple areas from the same
keypad when the system has been partitioned. Before operating
a different area, you will need to move the keypad to the area
that you want to operate.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [2] + [0] + [4].
A list of different areas will display on the keypad.
MENU 2-0-2
2. Use the [↑] and [↓] keys to select the area that you want
to move the keypad display to, then press [OK] to select.
Alternatively, you can enter the area number that you
want to move the keypad display to, then press [OK].
Area 1 Name
EXIT NOW
Area 1 Name
ARMED
Fri,Aug,13 5:34 pm
Area icons will only display if programmed to
do so by your security installer.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press , OK or MENU

MENU 2-0-3
MENU 2-0-4
Bosch Security Systems 09/06 BLCC110U