Dimm Module Replacement Procedure - Bosch DVA-12T Installation Manual

RAID Subsystem DVA-12T | Installation Manual
6.3.2

DIMM Module Replacement Procedure

NOTICE!
i
If you are going to replace or upgrade a DIMM module, please follow the instructions below. If
you do not want to replace or upgrade a DIMM module and would like to install a controller
module, please see Section 6.2.3 Replacing the Controller Module.
If a DIMM module fails or if a DIMM module with a higher memory capacity is required, the
onboard DIMM module must be replaced. To replace the DIMM module:
1.
2.
Fig. 6.2 Push Back the Module Clips on the Sides of the DIMM Module
3.
4.
Fig. 6.3 Insert the DIMM Module
5.
Bosch Security Systems
Remove the controller module. See Section 6.2.3 Replacing the Controller Module.
Remove the previously installed DIMM module from the DIMM socket. To do this, push
the white module clips on either side of the DIMM module down. By doing this, the previ-
ously installed modules will be ejected from the DIMM socket. (See Figure 6.2)
Gently pull the DIMM module out of the DIMM socket. (See Figure 6.2)
Insert the DIMM module into the DIMM socket. Align the DIMM module with the DIMM
socket. Once aligned, gently push the DIMM module into the socket. The white clips on
the sides of the socket will close automatically and secure the DIMM module into the
socket.
Reinstall the controller module. After the DIMM module has been properly installed, the
controller module must be reinstalled. To do this, align the controller module with the
controller module bay. Then gently push the controller module in the controller bay.
Carefully push the controller until you feel the contact when the board edge connectors
are mated to the backplane. Do not use force. If unusual contact resistance is felt, try it
again. Next secure the controller module into the subsystem by fastening the hand
screws on the sides.
Subsystem Maintenance and Upgrading | en
F.01U.027.798 | V1 | 2006.06
35