Removing The Cache Memory Dimm From And Reinstalling It Into The Controller-Drive Tray - Bosch DSA E Series Installation Manual

E2600 DSA E-Series iSCSI Disk Arrays
4
5
6
7
3.
4.
5.
NOTICE!
You must place the HIC in the same location in the new controller canister, being careful not
to scratch or bump any of the components on the bottom of the HIC or the top of the
controller card.
6.
7.
NOTICE!
Make sure that the seven-segment display ribbon cable is still connected to the motherboard
connector. If the ribbon cable is not connected, you must lift the center piece of the
motherboard connector, and insert the ribbon cable into the motherboard connector.
8.
9.
17.3 Removing the Cache Memory DIMM from and Reinstalling It
into the Controller-Drive Tray
1.
Bosch Security Systems
HIC Interface Connector
HIC Subplate
Zero Insertion Force (ZIF) Socket
Front Bezel
Remove the front bezel from the controller canister, carefully working it from side-to-side
until you can slide it off and gain access to the HIC.
Loosen the HIC thumbscrews that secure the HIC to the controller card.
Gently disengage the HIC from the controller card, and remove the HIC.
Note:
The connector is located on the edge of the HIC next to the thumbscrews.
Install the HIC in the new controller canister by gently pushing down on the HIC to seat
the pins correctly into the HIC interface connector.
Install and tighten the four HIC thumbscrews that secure the HIC to the controller card.
Reattach the front bezel to the controller canister by reinserting the four screws.
Reattach the bezel flex harness by gently lifting the latch on the ZIF socket, and inserting
the ribbon cable into the ZIF socket. Then push the ZIF socket closed.
Locate the cache memory DIMM to be removed from the failed controller canister.
Installation Manual
Replacing a Controller Canister and Related Components | en 125
- | V2 | 2012.09