4-8 Linux Setup
(2) Make sure that the two BMC Status LEDs of the PCI modules (for Group1/for Group2) are
turned off.
IMPORTANT:
perform (3) and on. Otherwise the BMC firmware may become damaged.
(3) Remove the power cord of the AC inlet A (for Group2).
(4) Check that the POWER switch of the PCI module for Group1 is turned on.
(5) Connect the power cord of the AC inlet A (for Group2).
(6) Make sure that two BMC Status LED for PCI modules (for Group 1/for Group 2) are
turned off.
IMPORTANT:
installing Linux for NEC Express5800/ft series. Otherwise the setup may not be
done properly.
Preparation is now completed. Start the installation of Linux for NEC Express5800/ft series.
While the BMC Status LED is red and blinking, do not
If the BMC Status LED is red and blinking, do not start