Selecting A Scan Resume Method - Kenwood TH-K40A Instruction Manual

The transceiver stops scanning at a frequency or Memory channel on which a
signal is detected. It then continues scanning according to which resume mode
you have selected. You can choose one of the following modes. The default is
Time-operated mode.
Time Operated
TO
mode
Carrier Operated
CO
mode
SEEK Seek mode
1 Enter Menu mode and access Menu No. 14 (RESUME
2 Rotate the ENC control to select a Scan Resume mode from "TO", "CO" or
"SEEK", then press [F] to store the setting.
3 Press [MENU] or [PTT] to exit Menu mode.
30

SELECTING A SCAN RESUME METHOD

The transceiver remains on a busy frequency or
Memory channel for approximately 5 seconds, and
then continues to scan even if the signal is still
present.
The transceiver remains on a busy frequency or
Memory channel until the signal drops out. There is
a 2 second delay between signal drop-out and scan
resumption.
The transceiver remains on a busy frequency or
Memory channel even after the signal drops out and
does not automatically resume scanning.
), then press [F].