Pre-Test Check List; Operation Checklist - Kenmore 30" Built In Wall Oven Installation Instructions Manual

Installation Instructions
#r
Pre-Test Check List
Remove all protective film if
present, and any stickers.
Check to be sure that all wiring is
secure and not pinched or in
contact with moving parts.
Check that the bottom trim is installed
properly (see page 11).
Check to be sure the mounting
screws are installed and flush with the
side trim, (see page 10).
Operation Checklist
Remove all items from the inside
of the oven.
Turn on the power to the oven.
(Refer to your Use and Care
Manual.) Verify that the bake and
broil units, and all cooking
functionsoperate properly.
Check that the circuit breaker is
not tripped or the house fuse is
blown.
Check that conduit is securely
connected to the junction box.
See Use & Care manual for
troubleshooting list.
[_ NOTE TO ELECTRICIAN:
The power leads supplied with this
appliance are UL recognized for
connections to larger gauge
household wiring. The insulation of
these leads is rated at temperatures
much higher than the temperature
rating of household wiring. The
current carrying capacity of a
conductor is governed by the wire
gauge and also the temperature rating
of the insulation around the wire.
NOTE: ALUMINUM WIRING
A. WARNING:
IMPROPER CONNECTION OF
ALUMINUM HOUSE WIRING TO
THE COPPER LEADS CAN
RESULT IN A SERIOUS PROBLEM.
B. Splice copper wires to aluminum
wiring using special connectors
designed and UL approved for
joining copper to aluminum and
follow the manufacturer's
recommended connector
procedure closely.
NOTE:Wire used, location and
enclosure of splices, etc., must
conform to good wiring practice and
local codes.
13