Advertisement
Available languages
Available languages
13. 3¼" x 10" Ducted Discharge
Only: Remove _
from
damper flap and attach DampedDuct
Connector
over
knockout opening with screws removed in Step 4 under
"PREPARE
THE HOOD".
Make sure damper
Pivot is
nearest to B/Back
Edge of hood.
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
14. 7" Round Ducted Discharge
Only: Re-install 7" Round
Duct Ptate removed in Step #1 under "PREPARE THE
HOOD". Install a 7" round damper (purchase separately).
Damper flap must open freely in direction of airflow (away
from range hood).
_
To accomodate
off-center
ductwork, the Damped
Duct Connector
can be installed up to 1-inch on
either side of hood center or the 7" Round Duct
Pmate can be installed
up to 1/2"on either side of
hood center. In extreme off-center
installations,
one end of the duct connector
may need to be
trimmed
to cmearthe emectrical cable cmampo
15. Non-Ducted
Installations
Only:
Require
a
Performance
Ring
to be attached to the blower
wheel.
To install ring:
1. Remove the Blower Wheel by rocking it side
to side and applying a slight force to pull wheel
from motor. Remove Retainin Rg_g
if
necessary.
2. Slide the ring onto the Small Diameter
End of
the wheel and down to the _
of the
wheel.
3. Reassemble
wheel to motor. Make sure Tab
on wheel fits into one of the Motor Smots.
4.
5.
Push wheel down until it is locked in place.
Check that wheel is properly positioned as
shown. Press Sections into place if necessary.
Make sure wheel turns freely.
TAPE
EDGE
TOP/BACK
DAMPER/
DUCT
CONNECTOR
.Vertical
d_scharge
oos_t_on snown)
WARNING:
To reduce
the risk of electric
shock, make sure power is switched
off at the
service
panel
Lock or tag service
panel to
prevent power from being switched
on acci-
dentally.
1. Connect House Wiring (120 VAC) to hood. Use a piece of
Cardboard
to protect the cooktop, if necessary.
A Cord Kit is available
- which enables the hood to plug
into a standard
120 VAC wall outmet,
See page 4 for Cord Kit information,
Cord Kit avaiJabme by calling Sears
at 1-80O-4-MY=HOME _
Use only with range hood cord=connection
kite that have been investigated
and found
acceptable
for use with this modet range
hood.
10
iiiiii
!!!!i_i
HOUSE
WIRING
(120 VAC)
CARDBOARD
(Use to protect
ceoktop)
Advertisement
