Reverse (Manual Tilt And Hydro Tilt Models); Stopping Engine; Procedure - Yamaha 8 Owner's Manual

2. Move the gear shift lever quickly and
firmly from neutral to forward.
N
Remote control models
1. Pull up the neutral interlock trigger (if
equipped) and move the remote control
lever quickly and firmly from neutral to
forward.
EMU27796
Reverse (manual tilt and hydro tilt
models)
EWM00190
WARNING
When operating in reverse, go slowly. Do
not open the throttle more than half. Oth-
erwise the boat could become unstable,
which could result in loss of control and
an accident.
Tiller handle models
1. Place the throttle grip in the fully closed
position.
ZMU02030
F
ZMU02866
2. On models equipped with a tilt lock le-
ver, check that it is in the lock/down po-
sition.
3. Move the gear shift lever quickly and
firmly from neutral to reverse.
N
R
Remote control models
1. Check that the tilt lock lever is in the lock
position.
2. Pull up the neutral interlock trigger (if
equipped) and move the remote control
lever quickly and firmly from neutral to
reverse.
EMU27820

Stopping engine

Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU27832

Procedure

1. Push and hold the engine stop button
Operation
ZMU02030
ZMU02867
24