Trim Rod (Tilt Pin); Shallow Water Lever; Tilt Support Knob; Top Cowling Lock Lever(S) (Turn Type) - Yamaha 8 Owner's Manual

To increase resistance, turn the adjuster
clockwise.
To decrease resistance, turn the adjuster
counterclockwise.
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
EMU26261

Trim rod (tilt pin)

The position of the trim rod determines the
minimum trim angle of the outboard motor in
relation to the transom.
EMU26280

Shallow water lever

Pushing this lever down will tilt the motor up
partially to provide more clearance when op-
erating in shallow water.
ZMU04508
EMU26320

Tilt support knob

To keep the outboard motor in the tilted up
position, push the tilt support knob under the
swivel bracket.
EMU26372

Top cowling lock lever(s) (turn type)

To remove the engine top cowling, turn the
lock lever(s) and lift off the cowling. When in-
stalling the cowling, check to be sure it fits
properly in the rubber seal. Then lock the
cowling again by returning the lever(s) to the
lock position.
ZMU02853
Basic components
ZMU02854
ZMU02855
14