Table of Contents
Advertisement
Installation
Instructions
EXHAUST
(CONT.)
SEALING OF JOINTS
• All joints should be tight to avoid leaks.
NOTE: The male end of each section of duct must point
awag from the drueE
• Do not assemble ductwork with fasteners that
extend into the duct. Theg will serve as a collection
point for lint.
• Ductjoints can be made air- and moisture-tight bg
wrapping the overlapped joints with duct tape.
INSULATION
• Ductwork that runs through an unheated area or is
near an air conditioning duct should be insulated to
reduce condensation and lint buildup.
PARTS AVAILABLE
FROM LOCAL SERVICE
ORGANIZATIONS
• Rigid Metal Duct Components
WX8X63
4" x 1' Duct
WX8X64
4" x 2' Duct
WX8XS1
4" Elbow
WX8X59
4" Aluminum Hood
• Flexible Metal Duct Components
Kit WX8X66-7' Aluminum duct, 4" hood and 2 clamps
WX8X65
7' Aluminum Flexible Duct
WX8X58
4" Clamps (2)
WX8X59
4" Aluminum Hood
MOBILE HOME INSTALLATION
• Installation must conform to Manufactured Home
Construction and Safetg Standard, Title 24 CFR,
Part 32-80,
• The druer must be exhausted to the outside with
the termination securel Ufastened to the mobile
home structure.
• The exhaust MUSTNOT be terminated beneath the
mobile home,
• The exhaust duct material MUSTNOT support
combustion.
CONSIDERATION MUSTBE GIVEN TO PROVIDEADEQUATE
CLEARANCES FOR INSTALLATION AND SERVICE.
ALCOVE OR CLOSET INSTALLATION
0_
1 rt
• If uour dryer is approved for installation in an alcove
or closet, it will be stated on a label on the back of
the drue_
• TO PREVENT LARGE AMOUNTS
OF LINTAND MOISTURE
FROM ACCUMULATING
AND TO MAINTAIN DRYING
EFFICIENCY, THIS MACHINE
MUST BE EXHAUSTED
OUTDOORS.
• DO NOT install this appliance with less than
the minimum clearances shown above.
CONSIDERATION MUST BE GIVEN TO PROVIDE ADEQUATE
CLEARANCES FOR INSTALLATION AND SERVICE.
CAUTION: DO NOT INSTALL THIS APPLIANCE IN A CLOSET
WITH A SOLID DOOR.
7
Advertisement
Table of Contents
