GE 49-90382 Installation Instructions Manual page 2

Installation Instructions
UNPACKING SPACEMAKER'"
rTj Remove tape two corner pads rear
and from
bottom corners of appliance.
j_] Using shipping corner posts, lag
the four the
appliance on its left side so the shipping base does
not rest on the floor.
Plastic spacer
block
Shipping Shipping Rear vent
blocks clips onlg
Mechanism Drain hose
shipping bolt
Foam
shippingpad Shipping carton
corner posts
Remove the foam shipping pad.
Remove the washer shipping bolt using the ratchet
with 3/8" socket, and remove the plastic spacer
block using the slip-joint pliers.
Return the appliance to the upright position and
locate it in the general area to be installed. Provide
enough space at the rear for installing the water
inlet hose.
Untape and open the washer lid.
Remove:
a. foam tub blocking pad
b. foam shipping blocks from rear of unit
c. tape from drger door
d. foam drger support pads
e. inlet hoses
f. From the back of the washer, remove the wire
shipping clips securing the drain hose. Plastic
clamps secure the drain hose to the right side
of the washer backsheet. These clamps form a
standpipe to prevent water siphoning. DO NOT
REMOVETHESECLAMPS.
J
Drger
support pads
UNPACKING SPACEMAKER'" (CONT.)
NOTE:
T he tub blocking pad, shipping bolt and plastic
spacer should be retained for use if the appliance is
transported at a later date.
r_ Remove clips holding the following:
a. inlet hoses
b. drain hose
c. power cord
PREPARING DRAIN HOSE
[_ Form "U" the end of the drain hose with a
shape
on
the hose pointed toward the drain.
TO]For an installation requiring a longer drain hose,
use the WH41X312 extra-long (108") drain hose.
Attach to the machine in the same manner as the
original hose.