Advertisement
On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in
lower holes, using one l/4-20xllA '' screw and 7mm lock washer on each side. In upper holes, using one l/4-20xllA ''
screw and 7ram lock washer on each side, shown A. In the cart, secure upper back panel to lower back panel using
one 1/4-20x1/2" screw and 7ram lock washer, shown B.
l/4-20xl/2"Screw
7ram Lockwasher
Qty.1
Qty.5
1/4-20x11/2" screw
Qty.4
screw
7ram
1/4"20x11/_"
Iockwasher
screw
7mm_
. ,..,
, ..,,
Lowerback
lock washer _',,4-,u×l!L
screw
i
First. remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia, making sure "OFF" is on the top. Attach using two #8-32x3/8" screws and 4ram lock washers. Press sideburner
control knob onto valve stem.
/
/
/'
/
Lockwasherj
'
Screw
Valve stdm
Screwsand Washers
removed from valve bracket
Sideburner
valvebracket
#8-32×3/8" screw
Qty.2
Control knob
4ram lock washer
Qty.2
Note: Use upper and lower
holes on fascia to
attach bezel
i!!i!!i!!!!!!i!i!!!
JJJJJJJJ
4ram
lock washer
#8-32x3/8"screw
Sideburnercontrolknob
20,464222809
Advertisement
