Dell 2355DN Service Manual page 76

Display message
Invalid Cartridge
Cartridge is not valid for
this machine
IP Conflict
IP address conflict.
Fax Job is completed with
error Incompatiable
Job cannot be accepted
because line is busy
Line Error
Check Fax Line
Fax Job is completed with
error : Line Error
Low Heat Error Power
Cycle
LSU Hsync Error Power
Cycle
Email Job is completed
with error : Mail excced
server support
Email Job is completed
with error : Mail too large
Memory Full
Service Manual
Alignment and Troubleshooting
Meaning
The toner cartridge you have installed
is not for your printer.
The network IP address you have set
is being used by someone else.
The received fax number is the
number stored
The receiving party did not answer or
the line is already engaged.
Your printer cannot connect with a
remote printer or has lost contact
because of a problem with the phone
line.
OR
No dial tone sounds
The printer has a communication
problem.
There is a problem in the fuser unit.
A problem has occurred in the Laser
Scanning
The mail size is larger than the
supported size by SMTP server.
Single page data exceeds the
configured mail size.
The memory is full.
4-36
Suggested solutions
Install a Dell-genuine toner cartridge,
designed for your printer.
Check the IP address and reset it if
necessary
Change the Junk Fax Setup option.
Try again after a few minutes.
- Try again. If the problem persists,
please wait for an hour or try a
different phone line if possible and
then try to connect again.
- Turn the ECM mode on. See ECM
Mode.
- Check that the phone line is
connected properly.
- Check that the phone socket in the
wall is working by plugging in another
phone.
Ask the sender to try again.
Unplug the power cord and plug it
back in.
If the problem persists, refer to the
troubleshooting for Fuser Error.
1. Unplug the power cord and plug it
back in.
2. Check if the connection between
the LSU and the main board is correct.
3. If the problem persists, replace the
LSU.
Divide your mail or reduce the
resolution.
Reduce the resolution and try again.
Delete unnecessary documents,
retransmit after more memory
becomes available.