Dot1X Forward-Pdu - D-Link DGS-6600-48TS Manual

DGS-6604 mm

dot1x forward-pdu

dot1x forward-pdu
no dot1x forward-pdu
Syntax
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x forward-pdu
CLI Reference Guide
Use this command to allow a 1X-disabled interface to forward 802.1X BPDU.
Use the no form of this command to disable the forwarding function on a 1X-
disabled interface.
None
802.1x BPDU is not forwarded when 802.1x is disabled.
Interface configuration
This command is only valid for physical port interface.
When the 802.1X functionality is disabled, and dot1x forward-pdu is configured
for a port, the received 1x BPDU on the port will be flooded to the ports where
forward-pdu is enabled and that are in the same VLAN.
This example shows how to enable 802.1X forward-pdu on a given interface.
Verify the settings by entering the show dot1x auth-configuration command.
dot1x forward-pdu
173