Sharp AJ-2105 Operation Manual page 30

INSTALLING THE PRINTER DRIVER
Installing onto Windows Me/98/95/2000/NT4.0 (Parallel interface)
The screen images in this section are those of Windows Me.
Make sure that the printer is connected to your computer.
1
Turn on the printer, and then turn on your computer.
2
If "Add New Hardware Wizard", "Update Device Driver Wizard",
3
"New Hardware Found" or "Found New Hardware Wizard"
window appear, click the "Cancel" button.
On Windows NT 4.0, the screen will not appear. Go on to the next step.
Make sure to click the "Cancel" button. If you continue installation without clicking
the "Cancel" button, you may not install the driver successfully.
Insert the supplied CD-ROM into your CD-ROM drive.
4
Double-click "My Computer" (
5
ROM (
Double-click the "Setup" (
6
Check if the appropriate language has been selected, and then
7
click the "OK" button.
Normally, the correct language is selected automatically.
After confirming the message in the "Welcome" window, click
8
the "Next" button.
Be sure to read the descriptions in the "ReadMe" window, and
9
then click the "Next" button.
Select the model of your printer, and then click the "Next" button.
10
28
) icon.
), and then double-click the CD-
) icon.