Troubleshooting for Anynet +
¦
Problem
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message
'Connecting to Anynet +
device...' appears on the
screen.
The Anynet + device does
not play.
The connected device is
not displayed.
The TV programme
cannot be recorded.
The TV sound is not
output through the
receiver.
[550_Aus]BN68-01895D-02Eng.indb 33
Possible Solution
Check if the device is an Anynet + device. The Anynet + system supports Anynet +
●
devices only.
●
Connect only one receiver (home theatre).
Check if the Anynet + device power cord is properly connected.
●
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
●
Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet + setup menu.
●
●
Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
●
Anynet + doesn't work in certain situations. (Searching channels, Operating
●
Plug & Play, etc.)
●
When connecting or removing the HDMI 1.3 cable, please make sure to search devices
again or turn your TV off and on again.
Check if the Anynet + Function of Anynet + device is set on.
●
Check if the Anynet+ device is properly connected to the TV and check if the Anynet +
●
(HDMI-CEC) is set to On in the Anynet + Setup menu.
●
Press the TV button on the TV remote control to switch to TV. Then press the TOOLS
button to show the Anynet + menu and select a menu you want.
Select View TV in the Anynet + menu.
●
●
Press the SOURCE button on the TV remote control and select a device other than
Anynet + devices.
●
Press P >/<, CH LIST, PRE-CH, and FAV.CH to change the TV mode. (Note that
the channel button operates only when a tuner-embedded Anynet + device is not
connected.)
You cannot use the remote control when you are configuring Anynet + or switching to a
●
view mode.
Use the remote control when the Anynet + setting or switching to view mode is
●
complete.
●
You cannot use the play function when Plug & Play is in progress.
Check whether or not the device supports Anynet + functions.
●
●
Check whether or not the HDMI 1.3 cable is properly connected.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
●
Search Anynet + devices again.
●
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables
●
may not support Anynet + functions.
●
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or
power cord or a power failure, please repeat the device scan.
●
Check whether the antenna jack on the recording device is properly connected.
●
Connect the optical cable between TV and the receiver.
English -
2009-09-16
11:13:01