Index of Contents... Page No. Index of Contents........................02 Declaration of Conformity………….………..……..…………........03 What’s in the Box………….………..……..…………............04 General Instructions for 230v Machines............05,06 Specific Safety for Drilling Machines..............06,07 Initial Assembly Instructions................07,08 Specification….………..……..…………................08 Illustration and Parts Description..............09,10,11 Operation of the Micro Drill..................12 Adjusting the Spindle Speed...................13 Routine Maintenance....................
Declaration of Conformity... A X M I N S T E R W H I T E Copied from CE Certificate The undersigned, Ole Stilling authorised by Shanghai SIEG Machinery Co., Ltd No.555 Caofeng Rd, South to No.17 Bridge of Caoan Rd, Shanghai, P.R China declares that this product: Micro Mill...
General Instructions for 230v Machines... A X M I N S T E R W H I T E Good Working Practices/Safety The following suggestions will enable you to observe good working practices, keep yourself and fellow workers safe and maintain your tools and equipment in good working order.
7. Try to arrange the drilling operation so that the drill tip does not come in contact with the table. 8. Always allow the drill to stop before removing drilling or swarf from around the job or the table. www.axminster.co.uk...
'What's in the box' list above. If any parts are missing please contact your supplier or our Customer Services personnel straight away using the numbers listed in the Axminster catalogue. Having unpacked the machine and checked it over, please store the packaging for a short period in case the machine needs to be returned to your supplier or ourselves for any reason.
Clean the spindle of any grease or oil and push the drill chuck (10) onto the spindle firmly. Turn the chuck to make sure it is tight. Put the handle (5) into the handle socket (7) and tighten with the wrench provided. (Fig 1) Specification Axminster No. 200021 Max Drilling Capacity. 6mm (1/4”) Spindle Travel 40mm (1.1/2”)
Illustration and Parts Description... A X M I N S T E R W H I T E Fig 3 Belt plastic cover Headstock Digital read out Control panel Star knob Fine feed wheel Handle Handle socket Collar Spindle Battery cover Drill Chuck Column Fence...
Page 10
A X M I N S T E R W H I T E On/Off rocker switch Fig 4 Fig 4a Depth collar & ring Fig 4b Fine feed knob Speed control knob Fig 4c Fig 4d Fuse Speed control panel Knurled knob www.axminster.co.uk...
Page 11
Illustration and Parts Description... A X M I N S T E R W H I T E Fig 5 Digital display Min/in Press “mm/in” button to select metric or imperial readings. On/Off For normal drilling operations press the ON/OFF switch Plus &...
Always stop the motor by turning the speed control knob fully anti-clockwise to “0”. If the machine is switched off via the rocker switch or unplugged whilst the motor is running then the speed control will need to be returned to “0” and then turned clockwise as above before the motor will start again. www.axminster.co.uk...
Adjusting the Spindle Speed... A X M I N S T E R W H I T E Fig 6 Small pulley Motor mount Fig 8 Pulley Loosen and remove the two screws on the belt cover. Fig 7 Large pulley Move the belt to the required ratio.
Need help?
Do you have a question about the D.R.O. Micro Drill and is the answer not in the manual?
Questions and answers