Panasonic DP-C266 Operating Instructions Manual page 13

6
Insert the SD Memory Card.
Push the Slot Cover to open it.
Insert the SD Memory Card as illustrated.
(Label side up)
7
Select "SD Card".
Only one storage device can be selected at
a time. When the "SD Card" is selected as
the storage device, the scanned image
cannot be saved to the USB Flash Memory
and Hard Disk Drive at the same time.
If the setting of Function Parameter "70 SD/
USB Memory Function" (General Settings
> Key Operator Mode) is set to "No", the
Confirmation screen displays the "Function
not available" error message and beeps.
If you do not touch any key for 3 seconds, or
select "Close" on the Touch Panel Display,
the machine will display the previous
screen.
For more details, refer to General Settings
in the Operating Instructions (For Function
Parameters) of provided CD-ROM.
8
Press the Start key.
When scanning from the Platen Glass, place
the next original and follow the instructions
described on the Touch Panel Display.
The scanned image is saved in the following
directory of the SD Memory Card.
Directory: \PRIVATE\MEIGROUP\PCC\DI\IMAGE
The data saved on the SD Memory Card
can be printed by this machine or another
DP-C322*, DP-C262*, DP-C354*, DP-
C264*, DP-C323*, DP-C263*, DP-C213*,
DP-C405, DP-C305, DP-C265, DP-C406,
DP-C306, and DP-C266. When printing
PDF or high-compression PDF data, install
and set up the Memory Card Print Utility. For
details, refer to the Help section of the
Memory Card Print Utility on the Document
Management System CD-ROM.
* Requires optional Printer Controller
Module for printing PDF data.
9
Push the SD Memory Card, and then
remove it.
Do not remove the SD Memory Card while
the Access Indicator is flashing.
Continued on the next page...
13