Panasonic AJ-YAC960P Installation Manual page 4

SDTI Interface Board
6.
Remove the five screws attached to the
spacers on the SDTI board.
7.
Attach the two flat cables supplied in the same
package as the SDTI board to the connectors on
the SDTI board.
Open the connector covers, insert the flat cables
so that the blue stickers are positioned on the top
surface, and then close the covers.
8.
Attach the power cable attached to the SDTI board to the connector on the SDI board.
SDTI board
Screws (x5)
Flat cables
Blue stickers
SDI board
Power cable
SDTI board
E-3
Covers