Installation - Panasonic AJ-YAC960P Installation Manual

SDTI Interface Board

Installation

1.
Check that the power of the VTR is off.
2.
Remove the two coin screws, and take off the top panel
from the main unit.
3.
Remove the screw, and remove the metal board clamp together with the screw. (This screw cannot be
removed from the clamp.)
4.
Remove the board (SDI board) inserted at the position marked "F4" on the main unit side.
(Do not disconnect the coaxial cables which are connected to the SDI board.)
5.
Detach the cable clamper which is attached to the SDI board.
Metal board clamp
Cable clamper
SDI board
E-2
Coin screws
Screw