Installing Express5800/320Ma System Software - NEC Express5800/320Ma Software Installation And Configuration Manual

If the operating system has been installed by the manufacturer, a Microsoft Certificate
of Authenticity is placed on the system equipment label at the rear of the system. In this
case, supply the information in
"The Post-IPL Procedure" on page
If the operating system has not been installed by the manufacturer, review the
information in "Overview of the IPL and Post-IPL Procedures" on page 2-2
Considerations" on page
procedure described in
post-IPL procedure.
N O T E S
1. The IPL procedure allows you to perform a single IPL
and then duplicate the system disk for bulk
deployment. If you are using a duplicate system disk,
perform only the post-IPL procedure described in
"The Post-IPL Procedure" on page
2. Software installation services are available. Contact
NEC Technical Support for details.
Installing Express5800/320Ma
Table 2-1 and perform only the procedure described in
2-9.
2-2, supply the information in
"Performing the IPL Procedure" on page

Installing Express5800/320Ma System Software

Chapter 2
System Software
Table 2-1, and perform the
2-6, followed by the
2-9.
2-
and "IPL
2-1