To Run The Descaling Programme - Miele CVA 5060 Installation And Maintenance Manual

Descaling the machine

To run the descaling programme

28
^ Touch the right arrow sensor to highlight the maintenance
symbol and touch the OK sensor.
^ Select "Descale" and touch the OK sensor.
^ Select "Start" and touch the OK sensor.
The display will guide you through the whole procedure.
Please follow the instructions to, for example, empty the drip
tray, fill the water container etc.
If the machine has already heated up, it will cool down
for approx. 10 minutes before starting to run the
descaling programme.
The descaling programme cannot be cancelled once
started. The programme has to be completed through to
the end. This is a safety measure to ensure that the
machine is fully descaled, and is important for the long-
term protection of the machine and to ensure it functions
correctly.
^ When the message appears in the display asking you
– to Add descaling agent, take the water container out and
fill it to the k mark with lukewarm water. (Do not use less
water than this because this would cause the descaling
programme to finish before it has been completed
properly).
Add 2 descaling tablets to the water. Allow the tablets to
dissolve fully before shutting the lid and putting the water
container back in the machine.
During the descaling programme, water containing descaling
agent will run out of the hot water and the central spouts. This
is followed by an activation period before a little more
descaling agent is dispensed.