Advertisement
^ Remove the protective foil from the
adhesive strips.
a
^ Push the metal strips flush up against
the side and rear walls of the housing
unit and stick them on to the plate
warmer (see illustration).
The third metal strip is not required if
the housing unit does not have a
rear panel.
The appliance must only be oper-
ated as a built-in appliance.
^ Build-in the combination appliance in
accordance with its own specific op-
erating/installation instruction booklet
and then reconnect the electricity
supply to the fused connection points
for both appliances.
a
b
b
After building in the combination appli-
ance, it may be necessary under cer-
tain circumstances to
– align the front of the plate warmer.
– align the gap between the plate
warmer and the combination appli-
ance.
To help you do this, there are adjusting
points underneath the nuts which se-
cure the drawer to the telescopic run-
ners.
^ Loosen the nuts and take the plate
warmer drawer out.
Use the adjusters to align the drawer
correctly.
23
Advertisement
