Page 1
IMPORTANT! It is extremely important to read and understand the entire contents of this Owner’s Manual for the Titan Industrial Model TG 7500D before at- tempting to operate the generator. This is a diesel engine powered, in- dustrial strength generating unit of electrical power. The diesel engine and the generator are both potentially extremely hazardous and could cause physical injury or even death if improperly used.
MODEL TG 7500D Industrial Generator TITAN INDUSTRIAL shall not be responsible for any consequences resulting from improper use of this equipment. The operator is required to read the entire contents of this manual before attempt- ing to operate the unit. If the operator does not completely understand the instructions and all of the hazards of operating this unit after reading this manual, he must call the factory at 1-800-845-4141 to answer these questions to his/her complete satisfaction before proceeding.
Page 3
SAFETY This generator was designed for specific applications. DO NOT attempt to modify the unit in any way or use it for any application that it was not designed to do. Ask the dealer or contact the factory if you have any questions concerning the generator’s application.
ENGINE BEFORE FILLING WITH OIL! indoors. Never fill fuel when Check air filter engine is hot or running. Do Titan Industrial not smoke or fill fuel near an open flame or sparks. Remove cover panel. Recommends Loosen wingnut and remove air Fill with diesel fuel only filter cover.
OPERATION OF THE GENERATOR Starting the Engine - Electric starting CAUTION! 1. Be sure unit is at a level, well ventalated position DO NOT start or stop the engine with electrical loads connected to the receptacles. Be certain connected devices are OFF before connecting or 2.
OPERATION OF THE GENERATOR Bleeding Instructions Figure #6 Rubber Fuel Line Fuel Pump Port Steel Fuel Line Fuel Pump Throttle Lever Figure #7 1. With the fuel valve in the off position take off the rubber fuel line off the fuel pump port. 2.
Page 8
RECEPTACLES AC Voltage Shows operating Starting Switch 240 volt receptacle Selection Switch voltage Hourmeter Twist Lock 120-Volt Receptacle DC Output Main Breaker 120- Volt (opens and closes Receptacle receptacle circuits) Remote Starting: The ignition key has to be in the run position to operate the remote. Battery Drain: When the unit is not operating always keep the ignition key in the off To avoid battery drain...
TROUBLESHOOTING Problem Cause Solution 1. Reset the circuit breaker. Engine is running but no 1. Circuit breaker is open. 2. Check & repair. 2. Poor connection or defective power output is available. 3. Connect another device cord set. that is in good condition. 3.
Need help?
Do you have a question about the TG 7500D and is the answer not in the manual?
Questions and answers