Major Operations And Their Functions; Front View (Door Opened) - Mitsubishi Electric DX-NV100E Installation And Operation Manual

Major operations and their functions

2
1
8
1 POWER indicator
When the POWER button is pressed while the MAIN
switch on the rear of this recorder is ON, this indicator
illuminates. When this recorder is in the standby status
or the MAIN switch on the rear of this recorder is OFF,
this indicator goes out. It takes about 1 to 2 minutes for
this recorder to be ready for operation after the POWER
button is pressed. When this recorder is in the process of
operation transition such as startup, this indicator blinks
and other operations are not acceptable.
2 HDD A, HDD B indicators (ACCESS indicators)
W h i l e H D D A o r H D D B i s b e i n g a c c e s s e d , t h e
corresponding indicator momentarily blinks. They keep
blinking during recording of data.
3 ALERT indicators (for HDD A and HDD B)
In case of an error of HDD A or HDD B, they blink or
illuminate.
4 REC indicator
This indicator illuminates when this recorder starts
recording. It goes out when the recorder stops recording.
5 ALARM REC indicator
This indicator illuminates when this recorder starts alarm
recording. It goes out when the recorder stops alarm
recording.
6 ALERT indicator
This indicator illuminates when the recorder notifi es an
important event such as an error occurring inside. And it
blinks when the LAN LINK has an error.

Front view (door opened)

3 4
9 10
7 IP-CAM indicator
T h i s i n d i c a t o r i l l u m i n a t e s w h e n I P c a m e r a s a r e
connected. And it blinks when the connection of an IP
camera has an error. It goes out when IP cameras are
not connected.
8 POWER button
The power is turned on when this button is pressed
while the MAIN switch on the rear of the recorder is ON.
When this button is pressed again, this recorder enters
the standby mode. When this recorder is in the process
of operation transition such as startup, the POWER
indicator blinks and other operations are not acceptable.
9 REC/STOP button
When this button is pressed, this recorder starts
recording and the REC indicator illuminates. When this
button is held down for 2 seconds or longer, this recorder
stops recording and the REC indicator goes out. When
this button is held down for 2 seconds or longer during
alarm recording, this recorder stops recording.
10 MIRRORING button
This button illuminates when the recorder is in a mirroring
mode.
11 SELF TEST button
The self test starts when this button is pressed. It brinks
during the test and it illuminates if no error is detected.
And the indicator goes out when the error is detected.
12 CANCEL button
When this button is pressed while the alert is indicated,
the indication is cleared.
5 6 7
11 12
9