Mitsubishi Electric DX-NV100E Installation And Operation Manual page 17

5 Turn ON the MAIN switch on the rear panel and
Step
then press the POWER button on the front panel of
this recorder.
6 After the recorder boots up and the buzzer sounds,
Step
press the TEST button.
• The management information deletion function is
activated and the HDD A or B indicator starts blinking.
Upon completion of the deletion, the indicator
illuminates.
7 S e t t h e M O D E r o t a r y s w i t c h t o t h e n u m b e r
Step
corresponding to the desired operation mode.
MODE rotary switch
0
1
2
3 to F
8 Press the POWER button on the front panel and
Step
then turn OFF the MAIN switch on the rear of this
recorder.
9 Attach the front unit.
Step
• Attach the unit and push it to the left.
10 Fix the front unit with screw and close the front
Step
door.
11 Turn ON the MAIN switch on the rear of this
Step
recorder.
12 Initialize the HDD using the supplied software for
Step
service.
Notice
• Note that when you initialize the HDD, the already
recorded data cannot be played any longer.
Before you initialize the HDD, check sufficiently that
there is no recorder having the same IP address in
the same network to prevent deleting the data in other
recorders unexpectedly.
HDD operation mode
Do not use
Spanning
Mirroring
Do not use.
17