Mitsubishi Electric LAN Control Utility User Manual page 24

8. Web UI
 Web UI Info screen
When you click [Info] on the control screen, the following screen will appear. This screen shows the information
and status of the currently connected projector. You can go back to the control screen by clicking [Exit].

 Projector Information
The following information of the projector is displayed.
Projector Name:
Location:
Mac Address:
Resolution:
Lamp Time:
Projector Model:
 Projector Status
The following information on the projector's status is displayed.
Power Status:
Input Source:
Lamp Mode:
Error Status:
Shows the projector's name.
Shows the name of the location where the projector is installed.
Shows the MAC address.
Shows the resolution of the video signal being projected.
Shows the lamp operation time as converted into that in the Low lamp mode.
<Note>
• When the projector's lamp mode is set to Standard, the lamp operation time
shown on this screen may be longer than the actual lamp operation time.
Shows the projector's model name.
Shows the projector's power status.
Shows the name of the source currently selected.
Shows the lamp mode currently selected.
Shows the following information if an error occurs in the projector.
Message in the [Error Status] box
3: Fan Error
3: Lamp Strike Failure
1: Lamp replacement recommended
3: Lamp replacement required
3: Projector Overheating
2: Temperature Warning
3: Lamp Cover Opened
4: Abnormal State Detected
<Note>
• When the projector is in the normal status, the [Error Status] box is blank.
The fan has an error.
The lamp has failed to illuminate.
The lamp life has ended.
The lamp life will end soon.
The projector is overheated.
The projector is about to be overheated.
The lamp cover is open.
The projector has an error.
EN-24

Error description